Shaft trimming instructions golfsmith

 

 

SHAFT TRIMMING INSTRUCTIONS GOLFSMITH >> DOWNLOAD LINK

 


SHAFT TRIMMING INSTRUCTIONS GOLFSMITH >> READ ONLINE

 

 

 

 

 

 

 

 











 

 

Trim (cut) the tip of the shaft only according to the trimming instructions specified official Nippon Shaft catalogues. Trimming (cutting) more than the specified length may cause breakage. Shafts should be installed/used only once. The shaft's material may deteriorate, and the original strength and performance may not be maintained due to the influence of heat and force when removing a shaft from a head. First using the longest iron in the set make up find the frequency desired. From that point you will tip 9/16 of and inch for each club until you get to the wedges. Wedge tipping varies according to the players or fitters requests. Keep in mind that every 3/16ths you tip will give you 1 frequency cycle on the rifle chart. Instructions for ALL NUNCHUK® Shafts. TIP TRIMMING - No tip trimming required or suggested for Drivers, Fairway Wood, Hybrids or Irons to adjust the "flex" of the shaft.. CLUB LENGTH TRIMMING - Butt trim all shafts to achieve desired club length. For Drivers, we believe you will get optimum performance if you do what the majority of PGA Tour players do and trim the finished length to 44 to 44.5 inches, rather than longer lengths typical of "off-the-rack" drivers. In general, tip trimming can be used to achieve a stiffer shaft profile, lower launch, and/or lower spin. Tip trimming 1" is equivalent to one flex. For example, if you wanted to stiffen your S flex to an X flex then you would tip trim 1". If you prefer to play shaft in between S and X flex, you would tip trim 1/2". VEYLIX ALPINA - PLASMA VAPOR. 100% 40T Carbon - Counter Balanced - Plasma Vapor Silver Coating. M ODELS. Alpina 573 - 53g wood shaft. Alpina 673 - 67g wood shaft. TRUTH IN C ONSTRUCTION. - One of very few 100% 40T Carbon shafts ever released; allows for density and strength, even at an under 50g playing weight. - Experimental Blind Bore - add 1/2" to trimming instruction. Standard Bore add 1" to trimming instruction. Shaft trimming is adjustable but should never exceed 2". (6)Through Bore - no change to tip trim. Standard Bore - add 1" to trimming instruction. (7)For all through bore woods insert shaft a maximum of 2". (8)For through bore woods, insert driver shaft 2" maximum, Fairway clubs tip trim ½" then insert shaft a maximum of 2". Do you know what happens to shaft stiffness when we trim a golf shaft? Tip trimming or butt trimming can change the shaft stiffness of your golf clubs. We lo

847, 667, 215, 896, 702.

0コメント

  • 1000 / 1000